Nylon

Hydlar Z - Aramid (Kevlar®) Fiber Filled

HYDLAR® is applicable to a wide variety of industrial applications where high strength, extreme wear resistance and low abrasiveness are required.Typical applications would be wear strips, bearings, bushings, rollers, gears and wherever wear and abrasion resistant materials are required.

Tecamid ST
 PropertiesASTM Test MethodUnitsInjection Molded & Extruded
Nylon 6/6Nylon 6/6 30% GFHYDLAR® Z
Physical
Base Material
--NoneGlassAramid
Content
-%0%30%N/A
Specific Gravity 73°F
D792-1.141.381.16
Water Absorption 24 hrs
D570%1.2.7.8
Water Absorption
  -  
Saturation 73°F
D570%8.55.46.3
Mechanical
Tensile Strength
D638psi x 10312.027.016.0
Tensile Modulus
D638psi x 106-1.51.3
Elongation
D638%66.03.04.0
Flexural Strength
D790psi x 10317.4-23.0
Flexural Modulus
D790psi x 106.411.30.9
Notched Izod Impact
D256ft lbs/in1.02.02.7
Compressive Strength
D695psi x 10313.024.019.3
Wear Factor***
D3702-860 to 110042479 - 128
Galling of Mating
     
Test Surface
--MinorSevereNone
Thermal
Heat Deflection Temp. 264 psi
D648°F194180470
Continuous Use Temp.
-°F210230300
Coefficient of Linear
     
Thermal Expansion
D696in / in /°F4.0 x 10-51.3 x 10-51.6 x 10-5
***ASTM Thrust Washer Test: PV=2,500 P=250PSI V=10 f.p.m.
This information is only to assist and advise you on current technical knowledge and is given without obligation or liability.
All trade and patent rights should be observed. All rights reserved. Data obtained from extruded shapes material.
HYDLAR® = Ensinger Industries, Inc.